只是个人看法，如果你喜欢ATC又想要有好的表现，为何不直接换19A？放大器直接给你配好了。
另外，其实ATC官方FAQ有告诉你想有好的声音表现，你的放大器应该要比较好的，当然取决你的需求。你可以参考一下从官方节录的FAQ。如果不追求三频均衡，我觉得你目前的功放听得开心就行了，也没必要再换。
黑格尔H190我目前用来搭ATC11，我觉得H190是一个推力很不错的机器，就是声音偏中性。另外我有参考黑格尔脸书官方的粉丝页，里面有黑格尔官方的销售人员，他们认为黑格尔H190不足以能完全驱动ATC19，ATC11应该是H190最好的搭配。
7. People say that ATC loudspeakers require a powerful amplifier and are difficult for amplifiers to run, is this true?
When engineering a loudspeaker, especially a smaller speaker, the choice has to be made between higher efficiency or an extended low frequency response. ATC’s smaller loudspeakers all offer excellent low frequency output for their size, with the downside of reduced efficiency. This means that a little more power is required to produce a typical listening level and as a result we recommend amplifiers with a minimum power output of 75W per channel into 8 ohms. It should be noted that all ATC loudspeakers have a nominal impedance of 8 ohms with a typical minimum of 5.5 ohms. As a result, they do not demand as much current as lower impedance loudspeakers and present an easier ‘load’ to an amplifier. This, coupled with the fact that as you drive a speaker with more power, the voice coil temperature will increase, in turn increasing the impedance, an amplifier with a higher power output into 8 ohms is likely to give better results than an amp with a lower 8 ohm power rating but that can double it’s power into 4 ohms.
|
粤公网安备 44030602000598号 耳机大家坛、www.erji.net、网站LOGO图形均为注册商标 
IP卡
狗仔卡
发表于 2024-2-4 01:13
收藏
分享
提升卡
置顶卡
沉默卡
喧嚣卡
变色卡
显身卡
楼主
